Build Your Own Actuator

SR & SX Deep Base Nema 4

SR & SX Deep Base Nema 4

The SR & SX series deep base rotary electric actuator was designed exclusively for applications within the 200 lb·in (model SR) and 300 lb·in (model SX) torque range with special control requirements. This heavy-duty reversing actuator is used in place of model SD and SDX when optional equipment such as 4-20mA control, timers and speed control are required. These compact actuators are equipped with spur gear drive and, as in all ICI actuators, can withstand stall conditions without suffering gear failure. The heavy-duty sand-cast aluminum enclosure meets NEMA 4 specifications and has a thermally bonded ultraviolet resistant polyester powder coating that not only enhances its appearance but also is a tough corrosion resistant coating.

Standard equipment includes 115Vac-1ph motor with thermal overload protection, two limit switches wired for light indication, stainless steel fasteners, 300 series stainless steel output drive and spring friction brake. Manual override and position indicator are not available on the S series deep base because the optional equipment used when this enclosure is specified prohibits their installation.

Specifications

Print Specifications
Output Torque 200 Ln-In (22.6 Nm) & 300 Lb-In (33.9 Nm)
Cycle Time: 5 sec/90° rotation
Duty Cycle: 25%
Motor: 115Vac-50/60Hz-1Ph. Standard
OPTIONAL VOLTAGES: 12Vdc, 24Vdc, 24Vac (24Vdc rectified) with manual reset (turn off then back on) overload protection. 230Vac-50/60Hz-1Ph.with automatic reset thermal overload protection and spring friction brake
Lock Rotor Current 115Vac. = .75 Amps., SX – 1.0 Amps.
230Vac. = .38 Amps.
12Vdc. = 4.0 Amps.
24Vdc. = 3.2 Amps.
24Vac. = 3.2 Amps.
Enclosure: NEMA 4 Standard
Die-cast aluminum with 300 series stainless steel captured screws and thermally bonded polyester powder coating.
OPTIONAL ENCLOSURES: NEMA 4X Sand-cast aluminum with 300 series stainless steel screws and manual override shaft and thermally bonded polyester powder coating.
Output Drive: ISO 5211 F05 (14mm female star) 300 series stainless steel.
Mounting: Universal, ISO 5211 F05 mounting pad
Manual Override: Not available
Lubrication: Permanent
Temperature: -40° F to +140° F (heater required at 0 F. and below).
Weight: 7Lbs.
Switches: 16 A. 125/250VAC
AVAILABLE OPTIONS: Extended duty (75%) motor (cycle time = 10 sec./90 ° ), maximum of 4 auxiliary switches, power off brake, declutching manual override with hand wheel, feedback potentiometer, 4-20mA positioner (equipped with 24vdc power supply for transmitter), 4-20mA position transmitter (requires 24Vdc power supply), compartment heater, heater and thermostat, breather, three position control, light indication, two wire control, timer, speed control, remote/off/local control panel, electronic torque sensor and one additional ½” NPT conduit entry.