Build Your Own Actuator

SNS20-28 ACTUATOR WITH BATTERY BACKUP

SNS20

Enclosure options include: NEMA 4, 4X, 7 and 9. The heavy-duty sand-cast aluminum enclosure has a thermally bonded ultraviolet resistant polyester powder coating that not only enhances its appearance but also is a tough corrosion resistant coating. Anodizing and epoxy coatings are offered as well.

NEMA 7 and 9 enclosures are perfect when the application requires equipment rated for Class I Groups C & D and Class II Groups E, F & G div. I and II environment. Despite a hostile environment, the Safe and Secure built in this explosion-proof enclosure can get the job done and lower the overall risk factor of the installation.

Safe & Secure Series is available in 115Vac, 230Vac, 12Vdc, 24Vdc, and 24Vac operating voltages to guarantee electrical compatibility and reliability with any process control around the world. It is equipped with 300 series stainless steel output shaft and heavy duty spur gear drive which, as in all ICI electric actuators, can withstand stall conditions without suffering gear failure.

Specifications

Print Specifications
TORQUE: 2000 Lb-In (226 Nm) to 2800 Lb-In (317 Nm)
CYCLE TIME: 12-14 sec. / 90°
DUTY CYCLE: 100% (standard)
INPUT VOLTAGE: 24 Vac & Vdc, 12 Vdc 115 & 230 Vac available with extra enclosure
BATTERY: 12 Volt 14.4 AHr Rechargeable Sealed Lead Acid Battery Minimum 4 Years Life in Stand-By Use at 68°F
CHARGER: Trickle charger drawing 1 to 1.3A during battery recharge and 50mA to maintain to full charge
ENCLOSURE: NEMA 4 (standard), C, US certified by CSA
NEMA 7 (optional), C, US certified by CSA
COATING: Thermally bonded polyester powder
POSITION IND.: Visual indicator
LUBRICATION: Permanent
WEIGHT: 40 Lbs
INSTALLATION: Universal
TEMP. RANGE: -40°F to 150°F
Heater & Thermostat required 0°F & below
OVERRIDE: Manual, declutching